Bm 10314 DANA 60/70 COVER WAS DESIGNED TO FIT BOTH DA User Manual download pdf

Instructions

Cast Aluminum Cover for

DANA 60/70

(see www.bmracing.com for the latest vehicle fitment applications and model years)

Part Number 10314

Printed in the USA 9500893-00

This B&M Cast Aluminum Cover

has been designed to work on most

vehicles equipped with a Dana 60 or

70 axle. The B&M Cast Aluminum

Cover provides several advantages

over stock factory covers. The extra

capacity provides increased oil

volume and added cooling, while the

thick aluminum construction

increases case rigidity. The

reinforced center bar, along with the

load bolts, prevents bearing cap

deflection under severe loads. The

magnetic drain plug feature allows

regular gear oil changes without the

usual mess, and limits ferrous debris

from circulating in the axle.

INTRODUCTION

This cover can be installed in about

an hour by carefully following the

instructions. It is suggested that the

vehicle be allowed to cool off for a

few hours to avoid burns from hot oil

and parts. The vehicle should be off

the ground for ease of installation -

jack stands, wheel ramps or a hoist

will work fine. MAKE SURE

VEHICLE IS FIRMLY SUPPORTED

- DO NOT WORK UNDER A

VEHICLE IF IT IS SUPPORTED BY

ONLY A JACK! Try to raise the

vehicle 1-2 feet so you will have

plenty of room to work. Also, have

a small box to put bolts in and a

drain pan to catch oil.

INSTALLATION

STEP 1. Clean axle housing cover

area from dirt and other debris.

NOTE: On some vehicles it

might be necessary to remove

some parts (e.g. sway bar,

panhard rod) to make the

installation of the cover easier.

STEP 2. Place a drain pan

underneath the axle housing.

STEP 3 (OPTIONAL). Loosen the

fill plug with a 3/8” square ratchet

and extension. This is done as a

precaution; if stock cover needs to

1 2 3

Cast Aluminum Cover for 1
DANA 60/70 1

Summary of Contents

Page 1 - DANA 60/70

Instructions Cast Aluminum Cover for DANA 60/70 (see www.bmracing.com for the latest vehicle fitment applications and model years) Part Number 1

Page 2

be re-installed for any reason, there will be no question whether the plug is seized or cannot be removed. STEP 4. Remove the 10 bolts around t

Page 3

Parts List (1) Cast Aluminum Cover (2) Load Bolts (2) Jam Nuts (1) ¼” NPTF Drain Plug (1) ½” NPT Filler Plug (10) 3/8”-16

Comments to this Manuals

No comments

Bm 10314 DANA 60/70 COVER WAS DESIGNED TO FIT BOTH DA User Manual

Browse online or download User Manual for For the car Bm 10314 DANA 60/70 COVER WAS DESIGNED TO FIT BOTH DA. B&M 10314 DANA 60/70 COVER WAS DESIGNED TO FIT BOTH DANA 60 AND DANA 70 DIFFERENTIALS. CONSTRUCTED OF A356.0-T User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Bm 10314 DANA 60/70 COVER WAS DESIGNED TO FIT BOTH DA