Bm 35498 BRACKET AND LEVER KIT User Manual download pdf

NOTE: Electronic transmissions

equipped with a PRNDL switch will

not work with this kit you will need

optional accessory kit #75498.

STEP 1. Raise and safely support the

vehicle at least 1-2 feet off the ground.

Remove the stock selector lever nut

and the selector lever. Discard the

stock lever and the stock shifter link-

age. Install the B&M selector lever in

position using the stock selector lever

nut (See Figure #1).Torque the nut to

23 lb-ft. The lever should move smoothly

from front to rear with a positive stop in

each gear position.

STEP 2. Remove the two transmis-

sion oil pan bolts from the middle of the

left side of the oil pan. Install the cable

bracket in position (See Figure #1).

The bracket must be installed with the

two spacers between the pan and the

bracket. (If your transmission is

equipped with a cast aluminum oil pan,

these spacers should be omitted. With

a TH-400 with a cast aluminum oil pan

the cable bracket may have to be

modified.) Install the two 5/16-18 x

1.00" bolts (Metric transmissions use

the two 8mm x 25mm bolts) supplied

and tighten 12-13 lb-ft. Do not over-

tighten as this can damage the pan

gasket.

WARNING: In some cases possible

modification to the cable bracket

9500195-05

Printed in U.S.A.

Installation Instructions

Bracket & Lever Kit

TH-200, TH200-4R, TH-250, TH350, TH400, TH700-R4,

4L60, 4L60E, 4L65E,4L80E & 4L85E

Part Number 35498

Use these two holes for

TH-400 transmission. Use

other two holes for other

GM transmissions

GM cable bracket

(Trimming of bracket

required if used on cast

aluminum pan)

Figure #1

Spacer

Cable swivel

Cotter pin

(Use hole specified

in Step 4)

GM lever

5/16 x 1" bolt and spacer

(Metric trans use M8 x 25 bolt)

7/16" nut

GM cable bracket

1 2

Summary of Contents

Page 1 - Bracket & Lever Kit

NOTE: Electronic transmissionsequipped with a PRNDL switch willnot work with this kit you will needoptional accessory kit #75498.STEP 1. Raise and sa

Page 2 - Selector Lever Hole Usage

might be required for the 4L80Eand 4L85E. Verify that selector le-ver does not grind on cable bracketbefore moving on to step 3.STEP 3. Route the shi

Comments to this Manuals

No comments

Bm 35498 BRACKET AND LEVER KIT User Manual

Browse online or download User Manual for For the car Bm 35498 BRACKET AND LEVER KIT. B&M 35498 BRACKET AND LEVER KIT User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Bm 35498 BRACKET AND LEVER KIT